Category Archives: Programming

TinyOS on the MSP430 Launchpads

10/1/2014 – Updated compilation instruction for the MSP Debug Stack

My semester project for CS5204 Operating Systems was to get TinyOS running on some unsupported MSP430 chips. While there are some resources out on the interwebs on how to get TinyOS running on specific hardware platforms, these platforms are designed with hardware for a specific use cases (ex. telos/micaz). What I wanted to do was to get TinyOS running on a generic development platform, or specifically on the TI Launchpads. There are two versions of the Launchpads in circulation: a value line that uses the MSP430G2xxx line of microcontrollers and a higher end board that uses the MSP430F5529 microcontroller. Here I’ll detail the process of setting up a TinyOS programming environment for both TI Launchpad platforms. I’ll also give a brief overview of TinyOS’s architecture.

Continue reading TinyOS on the MSP430 Launchpads

RGB LED Cube Controller

The latest code base for the controllers can be found here

12/28/2013 – Added Revision A Section
1/20/2014 – Added Revision A PCBs
1/26/2014 – Added Revision B Design
2/28/2014 – Populated Revision B Boards

As I had to take the LED cube home for a few days to fix a few things, I figured that I might as well extend its functionality. As such, I decided to add gaming functionality to the cube! To do so, I first had to design a controller to provide some way to interact with the cube. Originally I had hoped that someone from the AMP lab would take on this project, but no one seemed interested to do so (probably because it was finals week). Perhaps they would be more interested in programming games for the cube?

The controllers themselves should be pretty simple: a few buttons for inputs and some LEDs for things such as score indications. As such, it should be a relatively quick project. Perhaps I could put some sensors on the board as well, allowing for some gesture based control.

Continue reading RGB LED Cube Controller

RGB LED Cube

The latest code base for the LED cube can be found here

11/12/2013 – Updated code to use the WDT
12/12/2013 – Added support for controllers as well as Snake and Tron game modes

One of the projects that I’ve been working on for the last four months or so is an 8x8x8 RGB LED cube. After looking up some designs online of what others have built, I decided to design and build my own version. Instead of something shoddily put together, I wanted to build a display that could be put outside of one of the introductory lab rooms for other students to program and play around with. Thus, my design had a few goals:

  1. It had to look professional. This meant that the overall cube should be structurally sound and a proper PCB should be designed for the driving circuitry.
  2. It had to be fast. Since some sort of multiplexing would be needed to drive 512 LEDs, I wanted the cube to have at least 240Hz* refresh rate at the very minimum.
  3. It had to be driven from a microcontroller that is used in introductory classes. This meant that it had to be driven from a Digilent Cerebot 32MX7 board that is used to teach microprocessors here at Virginia Tech. While the cube itself isn’t limited to a specific microcontroller, by using this board I can write a baseline for the code from which other students can then easily build off of.
  4. It had to look impressive.

* – There’s actually a notable difference when driving the cube at 60Hz vs 240Hz.

Continue reading RGB LED Cube